A precision saw cut
We cut a narrow, dead-straight channel into the concrete along your driveway's lines — clean edges, no cracking, no guesswork.
Driveway lights · First in Calgary
Light, set into the driveway itself.
Saw-cut channel
Flush recessed finish
Only in Calgary from Starise
How it's built
Cut. Set. Glow.
This isn't a rope light glued to the surface. The light lives inside the concrete: a precision saw cut, a recessed channel, and a sealed LED strip that finishes flush with your driveway.
A recessed LED channel
A weatherproof channel is set into the cut, the LED strip drops in, and everything is sealed flush with the surface. You can drive over it.
Lines of light, every night
At dusk your driveway traces itself in crisp light. No fixtures to see in the daytime — just seamless glowing lines after dark.
How it works
From layout lines to light-up in a single visit.
01
Layout
We walk the driveway with you, map the light lines, and confirm power routing before a single cut is made.
02
Cut
A precision concrete saw opens a narrow, straight channel along the layout lines with clean, controlled edges.
03
Set & seal
The recessed channel and weatherproof LED strip go in flush with the surface, then everything is sealed against water, ice, and traffic.
04
Light up
We connect the system, test every run at dusk brightness, and hand you the controls.
First in Calgary
Nobody else in Calgary is doing this.
Recessed driveway lighting is big in Europe and just starting to appear in North America. Starise is the only company bringing it to the Calgary market — the same crew, the same clean-finish standard as our permanent lighting, now set into the concrete itself.
And it's not just Calgary: we install driveway lighting all over Alberta — Airdrie, Cochrane, Okotoks, Chestermere, Strathmore, Red Deer, Edmonton, and the mountain towns.
OnlyCompany offering it in Calgary
FlushDrive-over, plow-safe finish
SealedBuilt for Alberta winters
What it looks like on a family home.
Frequently asked questions
Everything you need to know about driveway lighting.
We map the light lines with you, cut a narrow channel into the concrete, set a weatherproof channel and LED strip into the cut, and seal it flush with the surface. Then we test every run and hand you the controls. Most driveways are done in a single visit.
Yes. The channel is cut into the concrete driveway you already have, so there’s no need to replace or re-pour it.
The cut is narrow and straight, made with a precision concrete saw along lines you approve before we start. The edges stay clean, and the channel is sealed once the light is set.
Yes. Everything finishes flush with the driveway surface, so cars roll over it like the rest of the concrete.
The LED strip sits in a weatherproof channel that’s sealed against water, ice, and traffic. The flush finish is plow-safe, so shovels and snow blowers pass right over it.
We plan the power routing with you at the layout visit and confirm it before any cutting starts. On install day we connect the system, test it, and show you how to control it.
Calgary and communities across Alberta, including Airdrie, Cochrane, Okotoks, Chestermere, Strathmore, Red Deer, Edmonton, and the mountain towns.
Still have questions? See all FAQs
Start here
Be the first driveway on your street to glow.
Tell us about your driveway and we will map out the light lines with you. Serving Calgary and communities all over Alberta.